Loading ...
Loading ...
Loading ...
en Programme default settings
14
Setting - - - -: Rinse Stop = no final spin.
The laundry stays in the water after the
final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the program has ended.
To continue/end the program
~ Page 19
The maximum speed that can be set
depends on the model and program
that has been selected.
Finished in-time
(ñ, Λήξη σε ñ)
Before starting the program, you can
preselect the program end ("Finish in"
time) in hourly increments (h = hour) up
to a maximum of 24 hours.
To do this:
1. Select a program.
The program duration is displayed
for the selected program, e.g. 2:30
(hours:minutes).
2. Press the Finished in-time button
repeatedly until the required number
of hours is displayed.
3. Press the A button.
The program starts.
The selected number of hours (e.g. 8
h) is shown in the display panel and
counts down until the wash program
starts. The duration of the program is
then displayed.
Note: The length of the program is
automatically adjusted when the
program is running.
Certain factors can affect the program
length, e.g.:
■ Program settings,
■ Detergent dosage (additional rinse
cycles if required due to foaming),
■ Load size/type of textiles (water
absorption differs),
■ Imbalances (e. g. due to fitted
sheets) are offset with several start-
ups of spin cycles,
■ Fluctuations in power supply,
■ Water pressure (infeeding speed).
Following the start of the program ,
you can change the preselected
number of hours as follows:
1. Press the A button.
2. Use the Finished in-time button to
change the number of hours.
3. Press the A button.
Following the start of the program you
can add or remove laundry as required.
~ Page 18
Loading ...
Loading ...
Loading ...