Loading ...
Loading ...
Loading ...
15
Installation instructions
Tronic 1000 T – 6 720 821 421 (2017/10)
5 Installation instructions
5.1 Location requirements and clearances
This electric storage water heater can be located outdoors or
indoors and should be installed in a location as follows.
▶ Ensure easy access to the thermostat, terminal box, and
element at the front of the water heater.
▶ Ensure easy access for service of the PTR valve.
▶ Locate the appliance as close as practical to the kitchen or
area of most frequent hot water use.
▶ Foundations must be stable and level. The combined
weight of the complete installation including the water
heater, stored water, and fittings must not affect the
integrity of any structure.
▶ The water heater must be accessible without the use of a
ladder or scaffold.
▶ Adequate provision must be made available for removal of
water that escapes from valves to avoid damage to
property.
▶ Information on the technical label must be able to be read.
▶ If possible, allow for sufficient height above the water
heater for anode removal and replacement.
5.2 Water connections
Cold and hot water connections are RP ¾" / 20mm BSP and
marked "Inlet" and "Outlet" respectively.
As the unit is dual handed, brass plugs are supplied to blank off
unused inlet and outlet fittings. All other fittings must be in
accordance with AS/NZS3500 and local regulatory
requirements
A heat trap must be installed in the hot water line as per AS/
NZS3500 and the hot water lines after the heat trap must be
insulated.
A non-return valve and isolation valve should be installed on the
cold water line of the water heater.It is recommended that a
union be fitted to the cold and hot water connections to allow
easy disconnection of the appliance.
WARNING:
Electric water heaters are heavy and bulky.
Australian States and Territories have a
Principal Occupational Health and Safety
(OH&S) Act which contains requirements
relating to the handling of large, bulky, or
awkward items. Persons installing this
electric water heater system must be aware
of their responsibilities and be adequately
trained and qualified in accordance with
local OH&S requirements
WARNING: Transport damage!
▶ To avoid transport damage, wait until the
appliance is at the installation location to
remove the protective packaging.
▶ Use straps to prevent the appliance from
becoming damaged.
WARNING:
The manufacturer’s warranty does not cover
any damage or defect caused by improper
installation, attachment or use of any type of
accessories (other than those mentioned in
this user manual) with this water heater. The
use of unauthorised energy-saving devices
may shorten the life of the water heater and
may endanger life and/or cause property
damage.
The manufacturer disclaims any
responsibility for such loss and/or injury
resulting from the use of such unauthorised
devices.
CAUTION:
All packaging materials must be removed
from the electric storage water heater prior
to its installation.
CAUTION:
The electric storage water heater should not
be located in an area where leakage of the
tank or water connection will result in
damage to the area adjacent to it or to lower
floors of the structure. A properly drained
safe tray must be used where property
damage could occur from water spillage (see
AS/NZS3500.4.2). Ensure this safe tray
does not become blocked.
Loading ...
Loading ...
Loading ...