User Manual - Page 7

For CR2B23T3BTK15. Also, The document are for others Summit models: CR2B23T3B, CR2B15T1B, CR2B23T4W, CR2B15T2W, CR2B15T1BTK15, CR2B23T4WTK15, CR2B15T2WTK15

Loading ...
Loading ...
Loading ...
7
ELECTRICAL CONNECTIONS
IMPORTANT SAFETY INSTRUCTIONS
Be sure your cooktop is installed and grounded properly by a qualified installer or service
technician.
This cooktop must be electrically grounded in accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No. 70, latest edition in the United States.
PROVIDING THE ELECTRICAL CONNECTION
Install the junction box under the cabinet and run either a 120 volt AC wire (for models CR2B15T1B
and CR2B15T2W) or a 220-240 volt AC wire (for models CR2B23T3B and CR2B23T4W) from the
main circuit panel.
Note: DO NOT connect the wire to the circuit panel at this time.
WARNING!
The electrical power to the cooktop must be shut off while line connections are being made.
Failure to do so could result in serious injury or death.
ELECTRICAL REQUIREMENTS
Observe all governing codes and local ordinances.
- Follow the guidelines for connecting the cables
- Before running the cooktop, check the reading on the electric meter and the circuit breaker regulator.
Check whether it is properly grounded and appropriately fused.
- The socket should be properly grounded and the circuit should contain a circuit breaker whose splitting
distance between 2 wires is at least 3mm (⅛”).
- If the product has an accessible output socket:
The yellow and green wires inside the cables of the AC source and the connecting cable of the product
should be grounded.
The manufacturer is not liable to any accident caused by ungrounded or poorly grounded cables.
Any issues related to power cables should be directed to the customer service center or a qualified
technician.
To avoid any accident, if the power cables are damaged or required to be replaced, the repair work
should be carried out using the special equipment operated by dealers.
- The socket should comply with relevant electrical standards, or should contain a 1P circuit breaker with
electrical loading of at least 40A.
The installation guide for the cables is shown on the following page.
Loading ...
Loading ...
Loading ...