Loading ...
Loading ...
Loading ...
5
INSTALLATION
Install the water inlet hose
CAUTION
1.
Fasten one end of the inlet hose to the tap.
Ensure there is a rubber washer inside the
hose before fastening. The washer prevents
water leakage.
Securely tighten the other end of the inlet
hose to the clothes washer inlet valve.
Ensure the rubber washer is inside the hose
before tightening.
When tightening the clamping nut, apply
even pressure. Do not apply too much force
or twist the valve as this may damage or
break the valve joint.
2.
3.
PLEASE NOTE
Be sure to install the correct HOT and
COLD water inlet hoses. Incorrect
installation can reduce performance or
damage the clothes washer.
water inlet hose
clamping nut
8 0~1000mm6
Position the drain hose
Ensure the drain hose is correctly mounted
between to 1000mm above the ground.860
The drain water may overflow if the drain hose
is below 860mm or decrease flow if placed
above 1000mm.
Diameter of “b” should be not less than 30mm,
and flow capacity not less than 40L/min.
b
Loading ...
Loading ...
Loading ...