Loading ...
Loading ...
Loading ...
en Fault, what to do?
40
Utensils not dry. Not enough rinse aid in the
dispenser, or none at all.
Refill rinse aid.
Programme without drying was
selected.
Select programme with drying.
~ "Overview of programmes"
on page 25
Water collecting in depressions
on the utensils and cutlery.
Arrange utensils in a sloping position,
arrange affected utensils as sloping as
possible.
The combined detergent used
has a poor drying performance.
Use different combination detergent with
better drying performance. Use of rinse
aid also improves the drying performance.
ExtraDry to increase drying not
activated.
Activate ExtraDry. ~ "Operating the
appliance" on page 28
Utensils were removed too early
or drying process had not ended
yet.
Wait until program ends or wait until
30 min after program ends before
removing utensils.
The eco rinse aid used has a
limited drying performance.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Door does not open automatically
at the end of the Eco 50°
programme. Door gap is not set
correctly.
Set the door correctly with the aid of the
installation instructions so that the door
gap is at least 70 mm - 100 mm.
Plastic utensils not dry. Special properties of plastic. Plastic has a lower heat storage capacity
and therefore dries less well.
Cutlery not dry. Cutlery not arranged properly in
the cutlery basket.
Separate cutlery if possible, prevent
contact points.
Cutlery not arranged properly in
the cutlery drawer.
Arrange cutlery properly and separate if
possible.
Appliance interior wet after
wash cycle.
No appliance fault. On account of the “Condensation drying”
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.
Fault Reason Remedial action
*Depending on the features of your dishwasher
Loading ...
Loading ...
Loading ...