Loading ...
Loading ...
Loading ...
13INSTALLATION
Please read before beginning installation.
The water connection to your ice and water product can
be self installed. However, it is recommended that you
seek advice from a licensed plumber before commencing
the installation.
TIPS & INFORMATION
IMPORTANT
Check for water leaks at all water connection points in
the first 2 to 3 hours after installation, and correct it in
case of any water leak. Recheck after 24 hours; if leak
still occurs, it is recommended to contact a licensed
plumber for advice.
Water is to be connected as per diagram below.
(WHE5160SAD shown)
Step 1.
Ensure that the refrigerator
is disconnected from power
supply.
Step 2.
Connect tap fitting to water
supply tap. Tap must be close
to the refrigerator.
Step 3.
Push the tube into tap fitting
past insertion mark.
Step 4.
Connect other end of tube to inlet on rear of refrigerator.
Step 5.
Turn on water and check all joints
and tubes for leaks.
Step 6.
Reconnect the power.
Step 7.
Move the refrigerator back into
place being careful not to kink or
split the tubing.
Step 8.
Switch ON Water Dispenser.
Using a large container, run the
water dispenser to clear air from
lines. This may take a few minutes.
Purge and dispense a minimum
of 2 litres of water. Initial water
may be black in colour. This is
residual carbon dust from the filter
and is non-toxic. If the water is
slow to shut off or the dispenser
is dripping, air may still be in the
lines. Either purge more water
through the system to remove
this air or allow some time for
the air to be removed over
subsequent dispensing.
TIPS & INFORMATION
IMPORTANT
As the water cut off is not instant, leave glass under
dispenser briefly until water has stopped flowing to
avoid spills.
Clean and empty the dispenser drip tray regularly to
avoid overflow.
If you have not used the dispenser for some time, discard
the first seven or eight cups of water (contaminants
could have settled in the water pipes).
Step 9
Switch ON Ice Maker.
Once the refrigerator has been running for at least 24
hours remove the ice bin and dispose of the first few
batches of ice to ensure that impurities have been flushed
from the system.
Party Ice
When the Ice Bin is removed from the cabinet the
Auto Ice Maker will continue to dispense ice into the top
freezer drawer.
Loading ...
Loading ...
Loading ...