Loading ...
Loading ...
BEFORE FIRST USE
• Read all of the instructions included in this manual.
• Remove all packing material and any stickers.
• Wash all removable parts in warm soapy water.
• Thoroughly dry all parts before reassembling.
• Select a location where this unit is to be used, leaving enough space (≈150mm/6 inches)
from the back and sides of the unit to allow heat to ow without damage to adjacent
cabinets and walls.
• Do not place near or below any curtains or other combustible materials.
• Insert crumb tray before use (Fig A). Slide the crumb tray into the space provide directly
below the oven door.
CAUTION:
• Do not operate the oven without the crumb tray installed.
• Do not cover the crumb tray with aluminium foil as this may cause the oven to
overheat.
• Install tray handle hooks (refer to the INSTALLING TRAY HANDLE HOOKS section of this
manual on page 4 for specic instructions).
• Plug unit into power outlet and switch the outlet on.
NOTE: You must set the timer for the pizza oven to function.
• Set the temperature to maximum (turn knob to either the Thin & Crispy or Frozen Snack
functions) and set the timer for approximately 20 minutes to condition/cure the elements.
Ensure the room is well ventilated.
NOTE: It is normal during this process for the new elements to give off some odour and a
small amount of vapour.
IMPORTANT INFORMATION ABOUT YOUR OVEN
• This unit is designed to cook signicantly faster than other cooking devices on most
settings. Do not leave unit unattended while in use.
• This oven gets hot. When in use, always use oven mitts when touching any outer or inner
surface of the oven.
• Do not use cooking sprays or oils on Ceramic Tray while using functions that have Medium
or High infrared intensity. Refer to the chart on page 5 of this manual for further information.
• During rst few minutes of use you may notice smoke and a slight odour. This is caused by
oil that may have been used during manufacturing of the unit and will not impact the
performance of this oven.
• The heating elements will cycle on and off during operation to maintain even heat
distribution.
3
Loading ...
Loading ...
Loading ...