Loading ...
Loading ...
Loading ...
14
INSTALLATION
Swing door
1
Open the door and remove the Two plastic hole
caps on the catch side by gently prying up with a
flat blade screwdriver. Save these for step 6.
Hole cap
2
While supporting the door, remove the 4 screws,
two from each hinge. Set the door aside face
down on a protected surface to prevent damage
to the door or the work surface.
Hinge screw
WARNING
The edges of the door cover may be sharp. Take
care when handling, or wear gloves to avoid
injury.
3
With the door on a protected surface, remove
the 16 screws on each side of the door and
lift off the inner door frame using a flat blade
screwdriver. Remove the latch hook and blank
and install them on the opposite side.
Latch hookBlank
Inner door
frame
4
Remove the 4 screws securing the hinges to
the door frame. Remove the two plastic cover
caps. Reinstall the hinges and cover caps on the
opposite sides from which they were removed.
Cover cap
Hinge
assembly
Tools Required
•
Phillips screwdriver
•
Large flat blade screwdriver (recommended
for hinge screws if they are tight or your Phillips
screwdriver is worn)
•
Small flat blade screwdriver (for lifting out parts)
WARNING
THE DRYER DOOR IS VERY LARGE AND
HEAVY. Failure to follow the instructions below
may result in damage to the dryer, property
damage or personal injury.
•
To avoid damage to the dryer or the door,
support the door with a stool or box that fits
under the door, or have an assistant support
the weight of the door.
•
Avoid dropping the door to avoid damage to the
door or the floor.
•
Unplug the dryer or turn off power at the main
circuit breaker before beginning door reversal.
Door Reversal Instructions
NOTE
The instructions here are for changing the door
swing from a right to a left side hinge. If the
door has been reversed, and it is necessary to
change it back, use care when following these
instructions. Some of the illustrations and the left/
right references will be reversed, and you will
need to read the instructions carefully.
WARNING
Be sure to support the weight of the door before
removing the hinge screws.
3828EL2001Q_en_170713.indd 14 2017-07-13 오전 11:21:01
Loading ...
Loading ...
Loading ...