Loading ...
Loading ...
Loading ...
Control Panel and Feature
HARD WATER
WASH
We understand that the water hardness may vary from region to region, wherein if the hardness is high,
you would not get good wash performance.
Hence to overcome this, we have introduced the unique HARD WATER WASH which allows you to add
extra detergent (recommended through display) and the machine adopts the agitronic motion to the
fabric type you have selected and performs the washing cycle accordingly.
ULTRA CLEAN
‘Bedsheet’
‘Woollens’
and ‘Wash Only’
.
will continue.
W
,
a
9
Control Panel / Installation
,
CHECK WATER
or that filter is .
Ensure that the tap is opened or else clean the fill hose filter first and then the inlet valve filter,
if required.
Machine that will resume automatically when the normal voltage comes back.
EXPRESS WASH
DELAY WASH
, as
up to a
, the
, refer to
to Very High.
.
.
20
If display shows ‘Lid Open’ with buzzer tone,
close the Lid to continue wash process.
If display shows ‘Lid Open’ without buzzer tone,
machine is waiting for water to be filled.
Close the Lid to continue wash process.
Special Features /
Trouble Shooting
agipeller
.
This error will pop up approximately after 10 minutes, if
there is no or very low water supply.
Check if the water tap is closed / water inlet pipe filter or
inlet valve filter is blocked with foreign objects.
If yes, open the tap / clean the filter
and then press the “START / PAUSE” button again.
Always ensure that there is adequate supply of water to
the machine.
Ensure that the washer is placed on a flat surface.
If Ub is displayed with the buzzer tone, open the lid and re-distribute
the laundry. Then close the lid and press ‘Start / Pause’ button.
Note: If off-balance is detected during spin cycle, washer
automatically fills water up to very high water level and goes
to wash process to balance the laundry load. If off-balance still
persists, the user will be alerted.
PF error indicates any power failure while “Delay Wash”
feature in is use.
This for the user’s information and will not impact
the wash process.
.
.
.
.
Check if any part of the drain hose is more than 20cm high from the
floor or if the extension drain hose is longer than 3m.
Ensure that the free end of the drain hose is not hooked up in the
machine. If so, put it down on the floor.
Make sure that there is no blockage in the drain hose and it should
be flat on the floor.
are
Ensure that you have checked the above points before calling the Whirlpool Service Centre.
that
Loading ...
Loading ...
Loading ...