Loading ...
Loading ...
Loading ...
8
Before first use, remove and safely discard any
packing material, promotional labels and tape
from the waffle maker.
1. Wipe the waffle maker cooking plates with
a damp sponge or cloth. Dry thoroughly
and close the lid.
2. Place the waffle maker on a flat, dry surface.
Ensure there is a minimum distance of
20cm of space on all sides of the waffle
maker. Do not place anything on top of the
waffle maker.
3. Unwind the power cord completely and
insert the power plug into a grounded
230/240V power outlet.
4. Turn the POWER | DARKNESS Control
Dial clockwise to the desired setting to
start pre-heating the waffle maker. The
POWER light will be illuminated.
5. Use the POWER | DARKNESS control
dial to adjust the brownness of your waffle.
There are 7 darkness settings ranging from
1 (lightest) to MAX (darkest). Rotate the
dial clockwise to increase the brownness
or counterclockwise to decrease it. When
making your first waffle we suggest using a
middle setting.
6. Once the waffle maker has completed
preheating, three audible alerts will sound
and the READY light will illuminate.
7. Open the lid and pour approximately ½
cup of batter evenly on the center of the
waffle plate. The batter should cover the
peaks of the waffle plate.
NOTE
When using the waffle maker for the
first time you may notice a fine smoke
haze. This is caused by the initial heating
of some of the components and is not a
cause for concern.
8. Close the lid but keep the locking latch
open. As the cooking cycle progresses
the READY light will switch off.
9. At the end of the cooking cycle, three
audible alerts will sound and the READY
light will illuminate. Open the lid and
carefully remove your waffles.
NOTE
There can be slight variations between
cooking cycles. If your waffles are not at
your desired darkness, close the lid and
cook for an additional minute.
10. For the most consistent results, add the
next batch of batter immediately after
removing the cooked waffle and repeat
steps 7 through 8.
NOTE
If the next batch of batter is not added
immediately after removing the cooked
waffle, close the lid and allow the waffle
maker to properly reheat (the READY
light will switch off and then back on)
before adding batter.
11. If you are not cooking any more waffles,
turn the POWER | DARKNESS control dial
to the OFF position.
OPERATING YOUR NEW BREVILLE PRODUCT
Loading ...
Loading ...
Loading ...