Loading ...
Loading ...
Loading ...
FIGURE 2A
LOCATION OF PLUMBING
AND ELECTRICAL
CONNECTIONS BEHIND UNIT
SIDE VIEW
..j,.
..J
.J
<c
21
._---- 141/4
FLOOR LEVEL
FIGURE 2B
ELECTRICAL THIN WALL
RIGID CONDUIT LAYOUT
SIDE VIEW
<
<
JUNCTION BOX
ON THE UNIT
18
FLOOR LEVEL
CONDUIT N BOX ON UNIT
I ]
BOX ON WALL CONDUIT
FRONT VIEW OF ELECTRICAL JUNCTION BOXES
TABLE 2A (REF: FIGURE 2A)
ITEM NO. DESCRIPTION QUANTITY
7 11/2'' TUBE TAIL - 12" LONG 1
8 %" PIPE - WATER SUPPLY
9 %" ANGLE VALVE - WATER SUPPLY
SHUT OFF 2
10 11/2"- 90° ELBOW -MALE/FEMALE 1
THREADS
11 11/2'' PIPE- DRAIN LINE
12 11/2'' J-BEND 1
13
14
31/2 FT. - 3 WIRE FLEXIBLE ARMORED
CABLE WITH NO. 12 AWG
INSULATED WIRE. OR IF LOCAL
ELECTRICAL CODES REQUIRE
RIGID CONDUIT FOR ELECTRICAL
WIRING SUPPLY 3 FT. OF RIGID
CONDUIT, 1/_,, DIA., 2 CONDUIT
CONNECTORS 31/2 FT. EACH -
WHITE, BLACK, GREEN NO. 12
AWG. INSULATED WIRE.
4" x 2" x 2" ELECTRICAL JUNCTION
BOX WITH COVER AND 6
ELECTRICAL WIRE NUTS
ELECTRICAL CONDUIT INSTALLATION
Using a conduit bender, form thin wall rigid conduit as
shown in Figure 2B. Insert the three wires in the conduit,
leaving sufficient lengths of wire at each end for electrical
connections in both boxes. Make sure power is off at the
wall box before proceeding further. Knock out the plug in
each junction box on the right of the center plug, at the top
on the wall box and at the bottom of the box on the unit.
Attach conduit to wall box. Do not connect wires at this time.
Set unit in place against wall to make sure conduit lines up
with the box on the unit. Make adjustment if necessary. After
alignment is checked, connect the electrical wires in the
wall box after removing the unit from wall. The unit box is
not connected at this time. Make sure the circuit is properly
grounded.
TABLE 2B (REF: FIGURE 2B)
ITEM NO. DESCRIPTION QUANTITY
15 ELECTRICAL JUNCTION BOX 1
16 ELECTRICAL CONDUIT
Loading ...
Loading ...
Loading ...