Loading ...
Loading ...
Loading ...
23
Installation
22
Troubleshooting
Drainage failure. Pump filter is blocked. Clean pump filter.
Drain hose end is higher than Make sure that drain hose
100 cm above floor level. is properly installed.
Drain hose is blocked. Unblock drain hose.
Strong vibration Machine load is not correct.. Adapt amount of laundry.
while spinning. Washing machine is located Make sure that washing
on an uneven surface or is machine is on an even sur-
not levelled. face and levelled.
Not all transportation bolts Remove all transportation
have been removed. bolts.
Operation stops Water or electric failure. Check power
.ylppus retaw dna gnitelpmoc erofeb
wash cycle.
Operation stops No displayed “error code“? Activate display - see “.display“.
for a period of time. Programme performs Touch “Start/Pause“ to resume.
soaking cycle?
Programme break down. If it seems appropriate
.noitarepo lecnac
Excessive foam Detergent is not a appropriate. Check detergent
.snoitadnemmocer ro/dna murd staofl
detergent drawer. Excessive use of detergent. Reduce amount of detergent
Automatic adjustment Washing programme This is normal and doesn‘t
of washing time. duration will be adjusted. affect functionality.
Spinning fails. Unbalance of laundry. Check machine load and
gninnips a nur dna yrdnual
.niaga emmargorp
Preparation
Remove all packaging material including polystyrene base.
While opening the package, water drops may be seen on
plastic bag and porthole. This normal phenomenon results
from water tests in the factory.
Dismantle the transportation bolts
The transportation bolts are designed for clamping anti-
vibration components inside the appliance during transpor-
tation.
1. Remove bolts on the rear side and take out
plasticspacers
from inner side of the machine.
2. Fill left holes with blanking plugs.
Adjusting the feet
Adjust all feets to achieve a complete level position.This will
minimize vibrations and noise during use. It will also
reduce wear and tear. We recommend to use a spirit level
for adjustment. Floor should be as stable and flat as possible.
Loading ...
Loading ...
Loading ...