Loading ...
Loading ...
Loading ...
-6-
EYE PROTECTION
which conforms to ANSI specifications and provides protec-
tion against flying particles both from the FRONT and SIDE should ALWAYS be
worn by the operator and others in the work area when loading, operating or ser-
vicing this tool. Eye protection is required to guard against flying fasteners and
debris, which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye
protection equipment must conform to the requirements of the American National
Standards Institute, ANSI Z87.1-1989 and provide both frontal and side protection.
NOTE: Non-side shielded spectacles and face shields alone do not provide ade-
quate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool
while the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
LOADING THE SB-1842BN/SB-1850BN/SB-2IN1
1. Disengage the latch and
pull back magazine side.
2. With magazine fully open
insert fasteners. Points
must be against bottom of
magazine.
3. Push magazine forward.
(SB-2
IN1)
2. With magazine fully open
insert fasteners.
4. Continue pushing until
latch is engaged.
Loading ...
Loading ...
Loading ...