Loading ...
Loading ...
Loading ...
Installation en
23
Fitting the filter cover
:Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
:Warning – Risk of injury!
Risk of trapping body parts when opening and closing
the hinges. Keep your hands away from the hinges.
1. Open the hinges on the filter cover.
2. Mount the filter cover on the designated screws and
push it backwards/forwards depending on the key
hole opening into the narrow section.
3. Tighten the fastening screws of the hinges.
4. Insert the metal grease filter.
5. Swing the filter cover up and ensure that it engages.
Removing the appliance
:Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
:Warning – Risk of injury!
Risk of trapping body parts when opening and closing
the hinges. Keep your hands away from the hinges.
1. Disconnect the appliance from the power supply.
2. Swing down the filter cover.
3. Remove the metal grease filters.
4. Press together the cable duct at the sides and
remove it.
5. Undo the screws on the hinges up to approx. 7 mm.
Note: Do not loosen them fully.
6. Unhook and remove the filter cover.
7. Loosen the screws on the fan box, remove the
ducting and pull out the mains plug. Then screw the
fan box firmly back in place.
8. Push the removal slide inwards to loosen the
mounting brackets.
9. Release the appliance slowly at an angle.
Loading ...