Loading ...
Loading ...
Loading ...
23
INSERT TANK The tank (A16) is not correctly in place. Insert the tank correctly and press as far as it
will go.
GENERAL ALARM The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,
as described in section “11. CLEANING”. If the
message is still displayed after cleaning, con-
tact a service centre.
EMPTY CIRCUIT FILL CIRCUIT
alternating with
HOT WATER
Press OK
The water circuit is empty Press OK (B12- g. 10) to deliver water from
the spout (C6) until it ows out normally. If the
problem persists, make sure the water tank
(A16) is fully inserted.
REPLACE FILTER The water softener lter (C4) is exhausted. Replace the lter or remove it as described in
section “14. WATER SOFTENER FILTER”.
SET DIAL TO CLEAN Milk has been delivered recently and the tubes
inside the milk container must be cleaned (D).
Turn the froth adjustment dial (D1) to the
CLEAN position (g. 26).
INSERT WATER SPOUT The cappuccino maker/hot water spout (C6) is
not inserted or is inserted incorrectly
Insert the spout as far as it will go.
INSERT MILK CONTAINER The milk container (D) is not inserted correctly. Insert the milk container (g. 24) as far as it
will go.
PROBLEM POSSIBLE CAUSE SOLUTION
The coee is not hot. The cups were not preheated. • Enable the cup warmer (A6), leave the
cups at least 20 minutes to warm up.
• Warm the cups by rinsing them with hot
water (Please note: you can use the hot
water function).
The internal circuits have cooled down
because 2/3 minutes have elapsed
since the last coee was made.
Before making the coee, heat the infuser by
rinsing using the "rinse" function (see section
“7.1 Rinsing”).
A low coee temperature is set.
Set a hotter coee temperature (see section
“7.10 Setting the temperature”).
The coee is weak or not creamy
enough.
The coee is ground too coarsely. Turn the grinding adjustment dial (A5) one
click anticlockwise towards "1" while the cof-
fee mill is in operation (g. 14). Continue one
click at a time until coee delivery is satisfac-
tory. The eect is only visible after delivering
2 coees (see section “8.4 Adjusting the coee
mill”).
The coee is unsuitable. Use pre-ground coee for espresso machines.
17. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
Loading ...
Loading ...