Loading ...
Loading ...
Loading ...
2
Mounting the controller
1. Using a drill bit of ⁄ inch diameter,
drill a hole to a depth of 1 inch
(25 mm).
2. Insert plastic anchor so it is ush
with the surface of the wall.
3. Screw 1 inch screw into anchor
leaving the head protruding about
⁄ inch (4 mm).
4. Slide the controller case over the
screw head.
5. Mark second mounting point (see
in diagram), remove controller, drill
hole, insert plastic anchor, slide
controller case over rst screw head
and screw into place.
Rear cable entry point
(remove with knife)
Conduit cable entry point
(remove with knife)
Wall mounting screw
Power indicator
Expansion module
cable entry
Go to previous screen
Go to home screen
Loading ...
Loading ...
Loading ...