Loading ...
Loading ...
3
INSTALLATION REQUIREMENTS
The SKT60* Trim Kit provides an integrated appearance when
installing an all-refrigerator and upright freezer side by side.
Plan the Installation
Plan your installation using these instructions in conjunction with
the Use & Care Guides provided with the refrigerator and freezer.
IMPORTANT:
■ For ease in handling and alignment, it is required that
2 people install the trim kit.
■ Make sure there is enough area, approximately 7 ft (2.1 m)
by 10 ft (3.1 m) to assemble parts on the floor.
■ Lay a drop cloth on the floor to cushion the parts and cover
the flooring.
■ These instructions are intended as a general guide only and
do not supersede any national or local codes in any way.
Compliance with all local, state or national codes pertaining
to this type of installation should be determined prior to
installation.
Opening Requirements
Make sure the opening is 74¹⁄2" (189.2 cm) high by 62¹⁄8"
(157.8 cm) wide by 24¹⁄4" (61.6 cm) deep as shown.
The inner opening dimensions of the installed trim kit will be
61.31" (155.7 cm) wide by 66.85" (189.7 cm) high.
NOTE: It is possible to make the trim kit fit vertical openings that
are less than 74¹⁄2" (189.2 cm) high. The trim kit can be reduced
in height by 1" (2.54 cm) increments. Each top grille (B) section
is 1" (2.54 cm) in height. For each top grille (B) section that is
not used, 1" (2.54 cm) must be cut from the base of both the
left-hand (E) and right-hand (G) side trim pieces.
Tools Needed
Assemble the required tools and parts before starting
installation.
Read and follow the instructions provided with any of
the required tools listed here. Proper installation is your
responsibility.
Tools Needed
■ Cordless drill, ¹⁄8" bit
■ Phillips screwdriver
■ Flat-blade screwdriver
■ Socket drive #2 bits
■ Torx
®†
T25 screwdriver
■ Carpenter’s level
■ Tape measure
■ Tape (masking or painters)
24¼"
(61.6 cm)
74½"
(189.2 cm)
62⅛"
(157.8 cm)
Parts Supplied
Remove the parts from the trim kit package. Make sure all parts
are included.
IMPORTANT:
■ Do not use sharp objects to remove packaging materials to
avoid scratching surfaces.
■ The metal parts can be damaged if they are dropped.
Description (Quantity)
Stainless
Steel Part
Number
White Part
Number
A. Top Trim Mount (1) W10682840 W10682841
B. Top Grille (6) (shown assembled) W10682846 W10682847
C. Top Trim Notched Grille (1) W10682843 W10682844
D. Top Plate (1) W10682876 W10682875
E. Left-Hand Side Trim (1) W10682850 W10682851
F. Gap Filler (1) W10682856 W10682857
G. Right-Hand Side Trim (1) W10682853 W10682854
H. Bottom Grille Assembly (1) W10682833 W10682834
I. Rear spacer (2) W10682858 W10682858
J. Bottom plate (1) W10907484
A
D
H
B
C
E
F
G
I
J
†
®
TORX is a registered trademark of ACUMENT INTELLECTUAL PROPERTIES, LLC
Loading ...
Loading ...
Loading ...