Loading ...
Loading ...
Loading ...
EN - 4
if water has not been drawn for 5
days.
- Store raw meat and sh in suitable
containers in the refrigerator, so that
it does not come into contact with or
drip onto other food.
- Two-star frozen food compartments
are suitable for storing pre-frozen
food, storing or making ice cream
and ice cubes.
- Do not freeze fresh food in one, two
or three-star compartments.
- If the refrigerating appliance is left
empty for long periods, switch off,
defrost, clean, dry, and leave the
door open to prevent mould develo-
ping inside the appliance.
INSTALLATION
The appliance must be handled
and installed by two or more persons -
risk of injury. Use protective gloves to
unpack and install - risk of cuts.
Installation, including water supply
(if any), electrical connections and
repairs must be carried out by a
qualied technician. Do not repair
or replace any part of the appliance
unless specically stated in the user
manual. Keep children away from the
installation site. After unpacking the
appliance, make sure that it has not
been damaged during transport. In the
event of problems, contact the dealer
or your nearest Aftersales Service.
Once installed, packaging waste
(plastic, styrofoam parts etc.) must be
stored out of reach of children - risk
of suffocation. The appliance must be
disconnected from the power supply
before any installation operation - risk
of electric shock.
During installation, make sure the
appliance does not damage the power
cable - risk of re or electric shock.
Only activate the appliance when the
installation has been completed.
Be careful not to damage the
oors (e.g. parquet) when moving the
appliance. Install the appliance on
a oor or support strong enough to
take its weight and in a place suitable
for its size and use. Make sure the
appliance is not near a heat source
and that the four feet are stable and
resting on the oor, adjusting them
as required, and check that the
appliance is perfectly level using a
spirit level. Wait at least two hours
before switching the appliance on, to
ensure that the refrigerant circuit is
fully efcient.
To guarantee adequate ventilation,
leave a space on both sides and
above the appliance. The distance
between the rear of the appliance and
the wall behind the appliance should
be 50 mm, to avoid access to hot
surfaces. A reduction of this space will
increase the Energy consumption of
product.
WARNING: When positioning the
appliance, ensure the supply cord is
not trapped or damaged.
WARNING: To avoid a hazard
due to instability, positioning or xing
of the appliance must be done in
accordance with the manufacturer
instructions.
It’s forbidden to place the freezer in
such way that the metal hose of gas
stove, metal gas or water pipes, or
electrical wires are in contact with the
freezer back wall (condenser coil).
ELECTRICAL WARNINGS
It must be possible to disconnect
the appliance from the power supply
by unplugging it if plug is accessible,
or by a multi-pole switch installed
upstream of the socket in accordance
with the wiring rules and the appliance
must be earthed in conformity with
national electrical safety standards.
Loading ...
Loading ...
Loading ...