Loading ...
Loading ...
Loading ...
Fault, what to do? en
27
Error code “:ƒ† is lit. Waste water pump blocked
or cover on the waste water
pump is not locked in position.
Clean pump and lock cover correctly. (See
Waste water pump)
Error code “:ƒˆ is lit. Mains voltage too low. Not an appliance fault, have the mains
voltage and electrical installation checked.
A different error code is
indicated on the digital
display.
(“:‹‚ to “:„‹)
A technical fault has probably
occurred.
Switch off appliances with the ON/OFF
switch (. After a short time restart
the appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the error
code.
Display flashes Door not closed properly. Close the door. Ensure that no objects
(utensil, fragrance dispenser) are protruding
over the basket and preventing the door
from closing.
Pause function activated. * Press the Start button again to continue the
rinse programme. *
Refill indicator for salt h
and/or rinse-aid ` is lit.
No rinse aid. Refill rinse aid.
No salt. Refill with special salt.
Sensor does not detect salt
tablets.
Use different special salt.
Refill indicator for salt h
and/or rinse-aid `
is not lit.
Refill indicator switched off. Activation/deactivation (see chapter Water
softening system/Special salt or Rinse aid).
There is still enough special salt/
rinse aid available.
Check refill indicator, levels.
Water is left
in the appliance at the end
of the programme.
Filter system or area under
the filters 1R is blocked.
Clean filters and area underneath (see
Waste water pump).
The programme has not yet
ended.
Wait until programme ends or reset (see
Terminating the programme).
Fault Cause Remedial action
Loading ...
Loading ...
Loading ...