Loading ...
Loading ...
Loading ...
en Fault, what to do?
26
Fault table
Fault Cause Remedial action
“Check water supply”
display )" lights up.
Supply hose kinked. Install supply hose without kinks.
Tap turned off. Turn on the tap.
Tap jammed or calcified. Turn on the tap.
Flow rate must be min. 10 l/min.
when water supply is open.
Filter in the water supply blocked. Switch off the appliance and pull out
the mains plug. Turn off the tap. Unscrew
water connection.
Clean filter in the supply hose. Screw water
connection on again. Check for leaks.
Reconnect power supply. Switch on
the appliance.
Error code “:‹ˆ is lit. Intake opening (on right inside of
appliance) covered by utensils.
Arrange utensils so that the intake opening
is not obstructed.
Error code “:‚ƒ is lit. Heating element calcified or
soiled.
Clean appliance with dishwasher cleaning
agent or descaler. Operate the dishwasher
with water softening system and check the
setting (see chapter “Water softening
system/Special salt”).
Fault code “:‚… is lit. Water protection system
activated.
Turn off tap.
Call customer service and mention the fault
code.
Fault code “:‚† is lit.
Fault code “:‚‡ is lit. Constant water inflow.
Error code “:ƒƒ is lit. Filters 1R are soiled or
blocked.
Clean filters.
(See Cleaning and maintenance)
Error code “:ƒ… is lit. Waste water hose
is blocked or kinked.
Install hose without kinks, remove any
residue.
Siphon connection still sealed. Check connection to siphon and open if
required.
Cover on the waste water pump
loose.
Lock cover correctly.
(See Waste water pump)
Loading ...
Loading ...
Loading ...