Loading ...
Loading ...
Loading ...
48
OPERATION
Starting the Engine
Starting a Cold Engine
1. Place the transmission in neutral and
lock the parking brake. Make sure
the fuel tank valve is on.
2. Sit on the vehicle and pull the choke knob
out until it stops (1). NOTE: If the knob
doesn’t stay where positioned, increase the
tension by rotating the tension adjusting
nut (2) clockwise.
NOTE: The variable choke is fully on when the
knob is pulled completely out. The choke is off
when the knob is pushed completely in. The
choke can be adjusted gradually, depending on
how much choke is needed for s tarting. Be sure the choke is off during
operation, as excess fuel washing into the engine oil will increase wear
on engine components.
3. Move the engine stop switch to RUN.
NOTE: Do not press the throttle while starting the engine.
4. Turn the ignition key past the ON position to engage the starter.
Activate the starter for a m aximum of five seconds, releasing the
key when the engine starts. If the engine does not start, release the
key and wait five seconds. Activate the starter for another five
seconds. Repeat this procedure until the engine starts.
5. If the engine slows, position the choke knob half way in to allow
proper engine warm up.
6. Vary the engine RPM slightly with the t hrottle to aid in warm-up.
When the engine idles smoothly, push the choke all the way in.
Engine exhaust contains poisonous carbon monoxide and can
cause loss of consciousness resulting in severe injury or death.
Never run an engine in an enclosed area.
WARNING
Operating the vehicle immediately after starting could cause
engine damage. Allow the engine to warm up for several
minutes before operating the vehicle.
CAUTION
1
2
Loading ...
Loading ...
Loading ...