Loading ...
Loading ...
Loading ...
en Cleaning and maintenance
34
impeller in the drain pump must be
able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
6. Place the service flap back on, lock
it into place, and close it.
Note: To prevent unused detergent
from flowing straight into the drain
during the next wash: Pour 2 litre of
water into compartment II and start the
Empty programme.
The drain hose at the siphon
is blocked
1. Switch off the appliance. Disconnect
the mains plug.
2. Loosen the hose clamp. Carefully
remove the drain hose, residual
water may leak out.
3. Clean the drainage hose and siphon
connecting piece.
4. Reattach the drainage hose and
secure the connection using the
hose clamp.
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
1. Turn off the tap.
2. Select any program (except Rinse//
Spin/Empty).
3. Press the A button.Allow the
program to run for approximately 40
seconds.
4. Turn the program selector to Off($).
Pull out the mains plug.
5. Clean the filter on the tap:
Disconnect the hose from the tap.
Clean the filter with a small brush.
6. For standard and Aqua-Secure
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
7. Connect the hose and check for
leaks.
Loading ...
Loading ...
Loading ...