Loading ...
Loading ...
Loading ...
Flashing display lights.
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
6
Lights What It Means What To Do
This is normal. Allow the dishwasher to drain and reset before you start a new wash cycle.
The
START/RESET
pad
has been pressed.
Control Error Press the
START/RESET
pad to turn off the beeper. If the
CLEAN
light continues
to flash, call for service.
Control Error Press the
START/RESET
pad to turn off the beeper and the dishwasher will
attempt to reset. Then restart the wash cycle. If this error continues, call for
service.
NORMAL
PLUS A
BEEPING
SOUND
RESET
STARTSTART
CLEANCLEAN
PLUS A
BEEPING
SOUND
Filling the Dispenser
Fill the rinse agent dispenser until it reaches the bottom
of lip inside the opening. Replace cap.
To check if rinse agent is needed:
On some models, remove the cap and look into the
dispenser.
On some models, press the clear center of the fill cap
2 or 3 times. If rinse agent fills the center of the cap,
you have enough.
A full dispenser should last about one month.
If rinse agent spills, wipe up the excess.
Check the Water Temperature
The entering water must be at least 120°F and
not more than 150°F for effective cleaning and to
prevent dish damage. Check the water temperature
with a candy or meat thermometer. Turn on the
hot water faucet nearest the dishwasher, place
the thermometer in a glass and let the water run
continuously into the glass until the temperature
stops rising.
Use Jet-Dry
®
Rinse Agent
Jet-Dry
®
rinse agent removes spots and prevents new film buildup on your dishes, glasses,
flatware, cookware and plastic.
Using the dishwasher.
Loading ...
Loading ...
Loading ...