D44528DZ User Manual

Loading ...

limits (L). For best results, use good quality peanut oil.

PREHEATING

• Placethefoodtobefriedinthebasket(I),withoutexceed-

ing the maximum level indicated on the basket (g. 6).

Check that the handle of the basket is correctly positioned

(pos. 2 in Fig. 2).

• Connecttothemainssupply.Bothlights(E)and(F)come

on.

PROGRAMMING THE DEEP FRYER

Usethe“-/+”buttons(B)tosetthetemperaturefrom248°Fto

374°F(120°Cto190°C).Pressingthebuttononceincreasesor

decreasesthetemperatureby9°F(5°C).

Use the MODE (C) button to access the temperature or time set-

tings.Usethe“-/+”buttons(B)toadjustcookingtimefrom0

to 60 minutes. Pressing the button once increases or decreases

time by 30 seconds. After setting the temperature and time,

presstheSTART/STOPbutton(D)(ifthetimehasnotbeenset,

the deep fryer will not begin the heating process). The deep fry-

er begins the heating process. The red light (E) comes on. During

this process, you can still modify temperature and cooking time

usingthe“-/+”buttons(B)andtheMODE(C)buttontomodify

the selection.

When the appliance reaches the set temperature, the green

light (F) comes on, the red light (E) go o and the deep fryer

emitstwo“beeps”.

STARTING FRYING

• Assoonasthe greenindicatorlight(F)comeson, lower

the basket (I) into the oil very slowly to avoid the hot oil

splashing or overowing.

• Closethecover.

• Pressthe START/STOPbutton (D).Thedisplay (A)shows

a countdown of the remaining cooking time. During this

process, you can still modify temperature and cooking

timeusingthe“-/+”buttons(B)andtheMODE(C)button.

At the end of the countdown the deep fryer emits three

beeps. Green lights (F) go o. The temperature returns to

thevaluesetpreviously.IftheSTART/STOPbutton(D)isnot

pressed, the appliance does not begin the countdown and

after 30 minutes the preset settings are restored.

• Asignicantamountofsteamwillbereleased.Thisiscom-

pletely normal.

• Itisnormalforsteamtobegivenofromthecoverand

condensation to drip from the edge of the cover.

• Toavoidburns,neverputyourhandsabovethecoverlter

or deep fryer itself while in use. Before opening the cover,

lift it slightly to allow steam to escape from one side.

END OF FRYING

• Attheendofthecookingtime,thedeepfryeremitsthree

“beeps”.Liftthebasket(I)andcheckthatthefoodhasbeen

cooked to the required colour.

• Unplugfromtheoutlet:

• Drainexcessoilbyhookingthebasket(I)tothesupport

(M) on the bowl.

• Note: If cooking requires two phases or more than one

cooking cycle is to be performed, at the end ofthe rst

phase, hook the basket (I) to the support on the bowl (M)

and wait for the light to go out. Then slowly lower the bas-

ket (I) into the oil again.

“OIL COUNTER” FUNCTION

This function monitors the length of time the oil has been used

and automatically indicates when it should be replaced. After

about5hoursofoperation,“OIL” is displayed and the appliance

emits a beep. The intermittent message is displayed at three

minute intervals. Replace the oil and reset the device by hold-

ingthe“counterreset”button(G)downforatleast3seconds.

Whentheapplianceisreset,itemitsabeep.Theapplianceis

now ready for the new oil countdown.

N.B.:

• When“OIL“isdisplayed,thisdoesnotpreventnormalop-

eration of the appliance.

• Thelifeoftheoildependsonwhatfoodsarebeingfried.

For example, coating with bread crumbs accelerates dete-

rioration of the frying oil. In this case, you are recommend-

edtoreplaceitbefore“OIL“isdisplayedandtheappliance

emits a beep.

• UseoftheLardFunctionautomaticallyresetstheoilcount-

er.

LARD FUNCTION

This function is useful when you want to use lard instead of oil.

• Beforepouringtheoil,makesurethattheoildraintap(Q)

is well-shut.

• Cutthelardintopiecesandplacethemdirectlyinthebowl

(K). You are recommended to use the following quantities:

MIN 8 lb (3750 g) - MAX 9 lb (4200 g).

• Settherequiredtemperatureandcookingtime,thenpress

thebutton(G).“LF” appears on the display and the deep

fryer starts melting the fat and bringing it to a temperature

of284°F(140°C).Afterabout15minutes,thelardwillbe

completely melted.

• Thetemperaturenowrisestothelevelsetpreviously.

• Assoonasthegreenlight(F)comeson,lowerthebasket

(I) into the melted fat very slowly to avoid it splashing or

overowing.

Loading ...

User Manual - Page 8