Loading ...
Loading ...
Loading ...
23
Drying result not
satisfactory.
The laundry clings to the sides of the
drum after being spun.
Loosen up the laundry by hand; start
the drying programme → page17.
Closed tap
Maximum load exceeded.
Drying time selected too short.
Turn on the tap.
Reduce the load for the programme
accordingly → page30.
Select the drying time according to the
load and the type of fabric.
Maximum or minimum load not taken
into account → page30
Once the programme has ended:
adjust the load quantity, select a
suitable drying programme and restart.
The fabric softener is not
completely flushed in or too
much water remains in the
compartment i
The fabric softener compartment insert
is not correctly attached or is blocked.
Clean the fabric softener compartment
insert and fit it correctly in the
compartment i → page19.
The laundry is not dried. The tap is turned off. Turn on the tap.
The laundry load is too large. Reduce the amount of laundry.
The drying time is too short. Select a suitable drying time.
No messages on the display
panel.
Power failure. The programme continues when power
is restored. If you wish to remove the
laundry during a power cut, you must
first drain out the water → page20.
Check whether:
– the plug is plugged into the socket
correctly.
– the circuit breaker (fuse) has
tripped; if it has, call the after-sales
service → page24.
The door cannot be
opened.
$ (Rinse stop) is selected. Select the programme + + 0 (Empty
+ Spin and press A (Start/Pause).
The programme is running or the door
is locked for safety reasons.
Wait until appears on the
display panel.
Power failure. Unlock the door mechanically.
Emergency unlock. In order to unlock the door mechanically in the event of a power failure, you will
have to:
turn the programme selector to Stop (Off) and unplug the mains plug from
the socket.
open the base panel and drain out the water → page20.
pull the emergency release downwards and open the door at the same time.
– Before opening the door, make sure that there is no water or hot
detergent solution in the washer dryer.
Under no circumstances open the door with the emergency release while the
drum is still turning.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to Stop (Off) and unplug the mains plug from the socket.
– Turn off the tap and call the after-sales service → page24.
Loading ...
Loading ...
Loading ...