Loading ...
Loading ...
Loading ...
11
4. Drill a 1/8” dia. pilot hole for house wiring,
at A location on template.
5. Use a sharp pencil or 1/8” drill bit to mark the loca-
tions for the appropriate duct access holes (16 locations
for 7” round duct, or 4 corner locations for rectangular
duct). Remove the template.
6. Draw the border for the exhaust ducting by linking its
marks (16 for round duct and 4 for rectangular duct), then
cut the opening in the cabinet bottom (vertical exhaust)
or in the wall (horizontal exhaust). Drill the house wiring
hole by using a 1½” hole saw centered with the pilot hole
previously made in 4.
FRAMED CABINET
Refer to the marking on the brackets to determine the
correct installation side and orientation.
7. Install the proper installation brackets according to the
type of cabinet (framed or frameless). See below.
7/64”
XY
Z
Mate the corresponding bracket to the cabinet side
frame, while placing rear end of bracket against the
wall. Use a pencil to mark 3 holes (there are 6 holes
but only 3 are necessary).
Remove the bracket. Using a 7/64” drill bit, drill 3 holes
where marked.
Assemble the bracket to the side frame using a Phillips
screwdriver and 3 provided no. 8 x 5/8” wood screws.
Repeat for the other side frame.
Loading ...
Loading ...
Loading ...