Loading ...
Loading ...
Loading ...
E-8
2012 January 31
HT-SL72 / HT-SL77 ZBxxx
3 Slot in the sound bar to the base stand according to your
TV size.
1. Fix the brackets to the holes as shown.
Caution:
● Be very careful to prevent the sound bar and TX-BOX
from falling when mounting on the wall.
● Before mounting, check the wall strength. (Do not put
on the veneer plaster or whitewashed wall. The sound
bar may fall.) If unsure, consult a qualified service
technician.
● Mounting screws are not supplied. Use appropriate
ones.
● Check all wall mount angle screws for looseness.
● Select a good location. If not, accidents may occur or
the sound bar may get damaged.
● SHARP is not responsible for accidents resulting
from improper installation.
● Do not let children dangle on the sound bar and TX-
BOX once it is attached on the wall as it can cause
damage and injury.
SHARP designed the sound bar and TX-BOX so you may
hang them on the wall. Use proper screws (not supplied).
See below for size and type.
System preparation (continued)
13 - 7/32"
(336 mm)
60" TV
70" TV
Groove to neatly
arrange the wire in.
Slot in the wire inside the
groove or slit for better
wire arrangement.
Suggestion of the
sound bars and
LCD TV arrangement.
3. To mount the sound bar on the wall
LEFT
RIGHT
(Model HT-SL77 : for 52", 60" and 70" TV)
(Model HT-SL72 : for 60" TV)
LEFT
RIGHT
(Model HT-SL77 : for 46" TV)
Caution:
Be careful not to
fix the bracket
upside down.
1 Fix the pattern paper to the wall in horizontal
position as below.
2 Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
3 Fix a wall mount plug (not supplied) into the hole
using a hammer, until it is flush with the wall
surface.
Driving screws
1/8" (3.2 mm)
3/8" (9 mm)
7/8" (Min. 22 mm)
3/16"
(5 mm)
Installing the sound bar
Fixing wall mount angle
Pattern paper
Wall surface
Wall surface
3/8" (8-9 mm)
1-1/4" (32 mm)
Wall surface
3/8" (8-9 mm)
1-1/4" (32 mm)
Loading ...
Loading ...
Loading ...