Loading ...
Loading ...
Loading ...
Accessing the turn signals and low beams
Follow general instructions, refer to page 193.
1. In the wheel house, loosen the two brack‐
ets and remove the cover.
Turn signal
21-watt bulb, PY21W
1.
If necessary, pull the inside trim of the
wheel house slightly inward. Turn the bulb
socket counterclockwise and remove.
2. Press the bulb gently into the socket, turn
counterclockwise and remove.
3. Install the new bulb and bulb holder in re‐
verse order of removal.
4. Attach the cover to the wheel house.
Low beams
55-watt bulb, H7.
1. Turn the cover counterclockwise and re‐
move.
2. Tilt the bulb down and then up to loosen it
from the holder and remove.
3. Pull the connector off the bulb.
4. Attach the connector to the new bulb.
5. First insert the bulb at the top with the
strap, arrow 1, and then press down firmly,
arrow 2. The bulb must audibly latch in
place.
6. Close the headlight housing with the lid.
Make sure that the lid engages.
7. Attach the cover to the wheel house.
Seite 195
Replacing components Mobility
195
Online Edition for Part no. 01 40 2 961 270 - II/15
Loading ...
Loading ...
Loading ...