Loading ...
Loading ...
Loading ...
41
Creasing. Laundry load exceeded.
Unsuitable program selected.
Do not exceed the maximum load for selected pro-
gram. Remove items of laundry immediately after the
end of the program, hang them up and pull into shape.
Press the center of the Program Selector to switch off
the appliance.
~ Program selection table; Page 32
Select Wrinkle Block button to prevent the laundry
from creasing or wrinkling.
~ Wrinkle Block; Page 33
Drying result is not sat-
isfactory (laundry feels
too damp).
Warm laundry may feel more damp
than it really is.
Remove items of laundry immediately after the end of
the program and press the center of the Program
Selector to switch off the appliance.
The selected program does not suit
the load.
Use another drying program or, in addition, select the
time program.
~ Program selection; Page 24
~ Program selection table; Page 32
Dryness level is not adjusted. Use Level Adjust to adjust the dryness level.
~ Level Adjust; Page 33
Fine layer of limescale or detergent
and textile care products residues
on the moisture sensors.
Clean the moisture sensors.
~ Cleaning the moisture sensors; Page 38
Program termination e.g. main
power supply failure, door open or
maximum drying time reached.
See the problem(s) mentioned in this table.
Initial load is too wet. Spin laundry at higher speed in the washing machine,
before drying.
Switch off the dryer, and then turn it on again.
Drying time too long. Lint filter and/or Condenser is dirty. Clean lint filter
~ Cleaning the lint filter; Page 36
and/or Condenser.
~ Cleaning the Condenser; Page 37
Insufficient supply of ambient air for
cooling.
Air inlet possibly blocked.
Ensure that cool ambient room air can freely circulate
near the dryer.
~ Installation for best performance; Page 9
Do not obstruct the air inlet on the front of the dryer.
Ambient temperature is lower than
59°F/15°C or higher than 86°F/
30°C .
Ensure the ambient room conditions are within this
range.
Program does not start
Finish in (remaining)
time is displayed.
A delayed starting time has been
selected and activated.
Drying cycle will begin at proper time to complete at
the selected Finish in time.
Program does not start
- D symbol lit up.
Child lock is activated. Deactivate Child lock.
~ Child Lock 3 sec.; Page 34
One or more indicator
lights are flashing.
Installation conditions are not ade-
quate.
Check the installation conditions.
~ Electrical Connections; Page 16
Fault in program sequence or mal-
function.
Switch off the dryer, allow it to cool down, switch back
on and restart the program.
Power failure. Remove laundry from the dryer immediately and
spread out. This allows the heat to dissipate. Be care-
ful as the door, the drum and the laundry may be hot.
Problem Possible cause(s) Solution(s)
Loading ...
Loading ...
Loading ...