Loading ...
Loading ...
Loading ...
22
CD-DP2400E_3.fm01/7/17
CD-DP2400E
Tape Recording
- Recording to a cassette tape -
Recording to a cassette tape
Before recording:
!
When recording important selections, make a preliminary test to ensure that the
desired material is properly recorded.
!
SHARP is not liable for damage or loss of your recording arising from malfunction
of this unit.
!
The volume and sound controls can be adjusted with no effect on the recorded
signal (variable sound monitor).
!
For recording, use only normal tapes. Do not use metal or CrO tapes.
Recording can be operated in the TAPE 2 compartment. The TAPE 1 is for playback
only.
"
Recording from a CD (CDs)
You can record 3 CDs continuously.
To perform programmed recording:
To stop recording:
Press the (CD ) button.
The CD and tape will stop.
Note:
When the end of the tape is reached whilst recording, the CD player will display the
track number which was being played at that time, and stop automatically. If you want
to restart recording from the beginning of the interrupted track, turn over the tape,
press the REC/PAUSE ( ) button and then the / (TAPE 2 ) button. (If tracks
have been stored in memory using the programmed recording, recording will restart
from the first track stored in memory.)
1
Press the ON/STAND-BY button to turn the power on.
2
Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the CD button and load the desired disc.
4
Press one of the DISC-1 - DISC-3 buttons to select the disc to be
recorded first.
5
Press the REC/PAUSE ( )
button.
Recording will be paused.
6
Press the / button on the main unit or the TAPE 2 button on
the remote control to start recording.
!
CD playback will start approximately 7 seconds after the tape starts.
!
Recording is started from the selected CD. When the playback of the last disc
is finished or the end of the tape is reached, the CD and the cassette will stop
automatically.
1Programme discs and tracks (see page 18).
2Press the REC/PAUSE ( ) button.
3Press the / (TAPE 2 ) button.
Downloaded from: http://www.usersmanualguide.com/
Loading ...
Loading ...
Loading ...