Loading ...
Loading ...
Loading ...
43
MAINTENANCE
ENGLISH
Replacing the Door
1
Firmly grasp both sides of the door at the top.
2
With the door at the same angle as the removal
position, seat the indentation of the hinge arms
into the bottom edge of the hinge slots. The
notch in the hinge arms must be fully seated into
the bottom edge of the slots.
Hinge arm
Indentation
Bottom
edge of slot
3
Open the door fully. If the door will not open fully,
the indentation is not seated correctly in the
bottom edge of the slots.
4
Lock the hinge locks, rotating them back toward
the slots in the oven frame until they lock.
Hinge arm
Hinge lock
5
Close the oven door.
Removing the Drawer
CAUTION
Disconnect the electrical power to the range at
the main fuse or circuit breaker panel. Failure to
do so can result in severe personal injury, death,
or electrical shock.
Most cleaning can be done with the drawer in place;
however, the drawer may be removed if further cleaning
is needed. Use warm water to thoroughly clean.
1
Fully open the drawer.
2
Locate the glide lever on each side of the drawer.
Push down on the left glide lever and pull up on the
right glide lever. You may need to pull the levers
out slightly to bypass the screws in the glides.
Push down with nger Pull up with nger
Lever Lever
3
While holding both levers, carefully pull the
drawer away from the range.
Replacing the Drawer
1
Pull the bearing glides to the front of the chassis
glides.
2
Align the glide on each side of the drawer with
the glide slots on the range.
3
Push the drawer into the range until the levers
click (approximately 2 inches).
4
Pull the drawer open again to seat the bearing
glides into position.
Door Care Instructions
Most oven doors contain glass that can break.
CAUTION
•
Do not close the oven door until all the oven
racks are fully in place.
•
Do not hit the glass with pots, pans, or any
other object.
•
Scratching, hitting, jarring, or stressing the
glass may weaken its structure causing an
increased risk of breakage at a later time.
Loading ...
Loading ...
Loading ...