Loading ...
Loading ...
Loading ...
15
Caution !
This appliance has only to be connected to a network 230 V~ 50 Hz
Connect always the earth wire .
Respect the connection diagram.
The connection box is located underneath at the back of the hob casing.To open the cover use
a medium screwdriver. Place it in the slits and open the cover.
Connection of the hob
The ceramic hob can be connected in different ways:
Biphase 400V~2P+N
Biphase 230V~2P
Monophase 230V~1P+N
Setting up the configurations:
For the various kinds of connection, use the brass bridges which are in the box next the terminal
Monophase 230V~1P+N
Put the 1
st
bridge between terminal 1 and 2, the 2
nd
between 4 and 5.
Attach the earth to the terminat “earth”, the neutral N to terminal 5 (or 4), the Phase L to one of
the terminals 1 or 2.
Biphase 400V~2P+N
Put a bridge between terminal 4 and 5.
Attach the earth to the terminat “earth”, the neutral N to terminal 5 (or 4), the Phase L1 to the
terminals 1 and the Phase L2 to the terminal 2.
Biphase 230V~2P
Put the 1
st
bridge between terminal 1 and 2, the 2
nd
between 4 and 5.
Attach the earth to the terminal “earth”, the Phase L1 to terminal 1 or 2, the Phase L2 to one of
the terminals 4 or 5.
Caution ! ensure that you :
- correctly attach the wires and the bridges.
- tighten the screws properly.
Before making the connection, we strongly advise you to locate the phase(s), neutral and earth
on the mains. If you have any doubts, call your electrician.
Note:
the bridge between terminals 4 and 5 is installed during the factory check.
We cannot be held responsible for any incident resulting from incorrect connection or
which could arise from the use of an appliance which has not been earthed or has been
equipped with a faulty earth connection.
Downloaded from www.ManualsFile.com manuals search engine
Loading ...