Loading ...
Loading ...
Loading ...
Faults and what to do about them en
33
3 Faults and what to do about them
Faults and what to do about them
Faults Cause/remedy
ç on the display panel. ■ Clean the fluff filter. Select the Start button to reset the displayed indication
and then select the Start button again to restart the appliance if necessary.
■ Check if exhaust air duct is blocked or bent. Clean the exhaust air duct
~ Page 32. If necessary, clean the insect screen on the exhaust air pipe.
Dryer does not start. ■ Mains plug plugged in or fuse checked?
■ Start button selected?
■ Dryer door open? Close the door.
■ Program selected? Select a program.
■ Childproof lock activated? Deactivate the childproof lock.
■ "Ready in" time selected? Program starts after a delay.
Display panel goes off
and Start button flashes.
Not a fault. Energy saving mode is active ~ Page 13.
Programme terminates
shortly after starting.
■ Ambient temperature greater than 5 °C?
■ Is the appliance loaded with the laundry?
■ Load too small for selected programme? Use timed programme.
■ Loaded laundry dry?
The door opens by itself. Push the door closed until you hear it engage.
Creasing. ■ Creasing occurs when you have exceeded the maximum load or selected
the wrong program for the type of fabric. All the required information can be
found in the program table.
■ Remove clothes immediately after drying. Creasing may occur if they are left
in the drum.
Water is leaking out. Not a fault. The dryer may be positioned on an incline. Level the dryer.
Laundry is not dried cor-
rectly or is still too damp.
■ After the end of the program, warm laundry feels damper than it actually is.
Spread the laundry out and allow the heat to disperse.
■ Finely adjust the dryness level – this extends the drying time but does not
increase the temperature. Your laundry will become drier
~ Page 27.
■ Select a program with a longer drying time or increase the drying level. This
does not increase the temperature.
■ Select a timed program for subsequent drying of laundry that is still damp
~ Page 25.
■ If you have exceeded the maximum load for the program, the laundry may
not be dried properly.
■ Clean the moisture sensor in the drum. A fine layer of limescale or particles
from the detergent and care products used in washing may residue on the
sensor and adversely affect it performance. It may cause that your laundry
will not dry properly
~ Page 32.
■ Drying has been interrupted as a result of a power cut, because the conden-
sate container is full or because the maximum drying time has been
exceeded.
Note: . See also the laundry tips
~ Page 24.
* depending on the model
Loading ...
Loading ...
Loading ...