Loading ...
Loading ...
Loading ...
BEFORE CALLING FOR SERVICE (continued)
Your washing machine is equipped with an automatic error-monitoring system to detect and diagnose problems at an
early stage.
Water in the washer
drains slowly or nat
at all, or the dlsplay
SHOWS:
I F_Fuc|
Washer fills with
water slowly or nat
at all, or the dlsplay
SHOWS,"
Cycle won't start, or
the dlsplay shows:
| ,-ac/I
| ,-n|
OL-'L-"|
The display shows:
I I H-u,:|
The display shows:
I J Fc0_-|
The dlsplay shows:
I FF
The display shows:
I f'_F,-,-|
The display shows:
J F
I L,:m
The display shows:
| PFll
Drain hose iskinked, pinched, or clogged.
The drain pump filter isclogged.
Drain discharge ismore than 96 inches above
bottom of washer.
Water supply faucets are not open fully.
Water line hoses are kinked, pinched, or
crushed.
Water inlet filters are clogged.
Water supply pressure to faucet or house
istoo low.
Water supply connected with leak-limit-
ing hoses.
The door is not closed properly.
Load is too small.
Load is out of balance.
Control error.
Water level is too high due to a faulty
water valve.
The water level sensor is not working
correctly.
A motor error has occurred.
A power failure has occurred.
Make sure the drain hose isfree of clogs, kinks,etc.,
and isnot pinched behind or under the washer.
Clean the drain pump filter. See Maintenance in the
Care and Cleaning section.
Adjust or repair drain. Maximum drain height is96
inches.
Make sure that the water faucets are fully open.
Make sure the hoses are not kinked or pinched.
Be careful when moving the washer during
cleaning and maintenance Clean the inlet filters.
See Maintenance in the Care and Cleaning sec-
tion.
Check another faucet in the house to make sure
that household water pressure is adequate and
flow is not restricted.
Hoses designed to limit leaks can trip falsely and
prevent the washer from filling. The use of leak
limiting hoses is not recommended.
Make sure that the door is closed properly and
press the START/PAUSE button. After starting
a cycle, it may take a few moments before the
drum begins to turn or spin. The washer will not
operate unless the door is locked.
If the door is closed and locked and the open
door error message is displayed, call for service.
Add 1 or 2 similar itemsto help balance the load.
The washer has an imbalance detection and
correction system. If individual heavy articles
are loaded (bath mah bath robe, etc.) and the
imbalance is too great, the washer will make several
attempts to restart the spin cycle. If an imbalance
is still detected, the washer will stop and the error
code will display.
Unplug the washer and wait 60 seconds. Reconnect
power and try again. If the error reappears, call for
service.
Close the water faucets, unplug the washeb and call
for service.
Close the water faucets, unplug the washeb and call
for service.
Allow the washer to stand for 30 minutes and then
restart the cycle. If the LE error code persists, call for
service.
If the power to the washer has been interrupted
during a cycle, the PF error code will display
the next time the washer is turned ON. This will
alert you to the fact that the previous cycle may
not have been completed. Select any cycle to
clear the error code and use the washer.
3O
Loading ...
Loading ...
Loading ...