Loading ...
Loading ...
Loading ...
10
THPD70
7. Options
7.1 Delay Function
Use this delay function to delay the drying programme from 0 to 24 hours. The delay time
means the programme will start after X hours. When the delay programme starts, the time
starts to decrease on the display and the “clock” icon blinks on your appliance display.
To activate the delay function:
— Load your clothing articles into your appliance and close the door.
— Press the On/Off button and use the programme selector dial to select your desired
drying program.
— You can select the “Anti-Crease” or “Signal” functions by pressing the corresponding
buttons, according to your needs.
— Now press the “Delay” button.
— Continue to press the “Delay” button to set your desired delay time.
— Once your desired delay time is displayed, simply press the “Start/Pause” button and the
dryer will automatically begin your selected drying programme at the completion of your
set delay period.
— If you press the “Start/Pause” button once again, the delay function will be paused. To
cancel the delay function, press the “On/Off” button.
7.2 Time Function
When the Warm, Cool or Refresh drying programmes are selected, the Time button can be
used to adjust the drying time. Each press of the “Time” button will adjust the drying time in
10 minute increments.
7.3 Intensity Function
Your appliance features a drying intensity control, allowing you to adjust the dryness level of
your laundry. The Intensity function has four levels, indicated by the icons below.
— The drying time increase by 3 minutes with each level.
— The Intensity function can only be activated before the drying programme is started.
— Press the Intensity button repeatedly to select the desired intensity (and drying time).
— The Intensity function can be used for all programmes except Cotton Iron, Quick,
Synthetic Iron, Baby Care, Warm, Cool and Refresh.
7.4 My Cycle Function
The My Cycle function can be used to define and save your favourite drying programme for
easier selection in the future (i.e. Use this function to save your most frequently used drying
settings).
To set your My Cycle function:
— Use the programme selector dial to select your required programme and select any other
drying functions.
— Press and hold the “Intensity” button for 3 seconds until the display flashes, indicating
that your desired
programme has been saved.
— To use your preset My Cycle, simply turn the programme selector dial to the My Cycle
position and press the “Start/Pause” button to begin.
— If you wish to change your My Cycle settings, simply repeat the steps above at any time.
7.5 Light Function
Your Teka Heat Pump Dryer has an integrated light inside the drum to assist with viewing
your clothing.
Press the “Light” button to activate the internal light for 3 minutes when the door is closed
or the dryer is in operation, or 1 minute when the door is open.
Loading ...
Loading ...
Loading ...