Loading ...
Loading ...
Loading ...
45
If Something Goes Wrong
Before You Call For Service
Oven will not
start
“PLEASE INSERT
PROBE
“ appears
on display
“SENSOR ERROR”
appears on display
Floor of the oven is
warm, even when
the oven has not
been used
“BAD PROBE”
appears on display
“LOCKED” appears
on display
Food amount too
large for Sensor
Reheat
When using a Sensor • Do not open door until steam is
feature, the door was sensed and time is shown counting
opened before steam down on display.
could
be detected.
Steam was not detected
•
Use Time Cook to heat for more time.
in maximum amount of
time.
Problem Possible Cause What to Do
A fuse in your home • Replace fuse or reset circuit breaker.
may be blown or the
circuit breaker tripped.
Power surge. • Unplug the microwave oven, then plug
it back in.
Plug not fully inserted • Make sure the 3-prong plug on the
into wall outlet. oven is fully inserted into wall outlet.
Probe has been • Insert the probe properly into the
forgotten or not oven wall outlet.
inserted properly.
The cooktop light is • This is normal.
located below the oven
floor. When the light
is on, the heat it
produces may make the
oven floor get warm.
The probe has not been • Insert the probe properly into the
completely inserted into oven wall outlet.
the oven wall outlet.
The probe is defective. • Replace the probe.
The control has been • Press and hold CLEAR/OFF for
locked. about 3 seconds to unlock the control.
Sensor Reheat is for • Use Time Cook for large amounts
single servings of of food.
recommended foods.
Loading ...
Loading ...
Loading ...