Loading ...
Loading ...
Loading ...
9
CUSTOM OVERLAY PANEL INSTALLATION
IMPORTANT:
Create custom overlay panel according to the
specifications in the “Custom Overlay Panel” section.
JennAir is not responsible for the removal or addition
of molding or decorative panels that would not allow
access to the refrigerator for service.
1. Open the door completely to 90°.
2. Remove the gasket from the corners of the door,
pulling gently until the two screw holes in each
corner of the door can be seen.
NOTE: The gasket does not have to be removed from
the door, only the corners.
3. Using two people, hold the custom overlay panel
against the door. Be sure that the top and bottom
hinges fit accurately into the routing on back of the
custom wood panel.
NOTE: Handle needs to be installed before the custom
overlay door panel has been installed on the refrigerator
door.
4. Fasten the custom panel to the door using two wood
screws (provided in installation kit) at each corner.
5. Press the gasket firmly back into it’s original position.
90°
A
A
B
A
A
A. Screw holes
B. Gasket
A. M4 x 30 flathead screws (provided in installation kit)
Loading ...
Loading ...
Loading ...