Loading ...
Loading ...
Loading ...
15
OPERATION CONTROLLER WITH RECEIVER
(SEPARATED FROM INDOOR UNIT) FOR F1 TYPE
A:Operation controller
(separated from indoor unit)
You can operate this air conditioner using the operation controller without the wireless
remote controller.
B:Remote control receiver
This section picks up infrared signals from the wireless remote controller
(transmitter).
C:ON/OFF operation button
This button is for turning the air conditioner on and off (automatically setting cooling
or heating operation).
D:SWEEP button
Use this button to make the airflow direction sweep up and down automatically.
E:SERVICING switches
These switches are used only when servicing the air conditioner.
Do not use these SERVICING switches for normal operation.
F: Switch
Usually set this switch in to the NORMAL position.
G:ADDRESS switch
When operating the air conditioner by using the wireless remote controller, be sure to
match the number on this switch with the number set on the wireless remote
controller. Otherwise, the remote controller will not work.
H:OPERATION lamp
This lamp lights when the appliance is turned on.
I: TIMER lamp
This lamp lights when the system is being controlled by the timer.
J: STANDBY lamp
When the unit is in the heating standby condition, the STANDBY lamp lights. If the
unit is used for cooling only, the STANDBY lamp will not illuminate. This lamp
operates only when an alarm occurs.
K:FILTER lamp
This lamp lights when the filter needs cleaning.
Turning off the ON/OFF operation button does not disconnect the power. Use the main
power switch to turn off the power completely.
B: Remote control receiver
C: ON/OFF operation button
D: SWEEP button
E: SERVICING switches
F: Switch
G: ADDRESS switch
H: OPERATION lamp
I: TIMER lamp
J: STANDBY lamp
K: FILTER lamp
A: Operation controller
163011_SingleSplit_EN_2.fm Page 15 Thursday, September 15, 2011 9:03 AM
Loading ...
Loading ...
Loading ...