Loading ...
Loading ...
Loading ...
17
PROBLEM EASY SOLUTION
Odd noise from the
juicer
•
Check if the parts are assembled correctly. Try reassembling the parts and
listen for the odd noise.
•
Do not start the juicer unless there are ingredients and/or liquid in it.
•
Operating the juicer without ingredients can cause damage to the screw.
•
If the juicer is operated without ingredients or liquid, the noise level can
increase and also can lead to damage.
•
The friction noise from the juicing screw and the strainer will disappear when
ingredients are inserted into the juicer.
•
If the noise occurs when ingredients are inserted into the juicer, check the size
of the ingredients. Do not insert anything over 3cm in thickness.
•
Depending on the type of ingredients, the dimensions can be smaller.
•
The noise can occur if the juicer is operated on an uneven or slanted surface.
Place the juicer on a horizontally flat surface when operating.
The extracted pulp is
very moist
•
During the very beginning of extraction, the pulp can be more moist.
•
Depending on the ingredient’s condition, the extracted pulp can be affected;
especially when the ingredient is not fresh, the juice can be extracted with the
pulp.
During operation, the
juicing bowl shakes
•
The juicing screw and the strainer are set up to crush and squeeze the
ingredients. It is normal for the juicing screw and the strainer to vibrate.
•
If the ingredient contains strong fibre, the vibration from the top-set may be
stronger.
During juicing, the
juicer stopped
•
Check the power cord and make sure it is plugged in correctly.
•
Check that all the parts are correctly assembled.
•
If too many ingredients are inserted at one time, this can cause the juicer to
stop.
•
When the juicer stops because there are too many ingredients inserted in it,
press the REVERSE - OFF - FORWARD button in this order, switching back
and forth 2 to 3 times. The reverse setting will push the ingredients up and
the forward setting will pull the ingredients down.
•
After using more than 30 minutes, if the juicer stops due to the overload
protection, let the juicer cool for 30 minutes to 1 hour before juicing again.
•
If there are hard seeds within the ingredients, remove them before juicing.
Hard seeds can damage the juicer
Layers of separation in
the juice
•
Depending on the density of the ingredients, the extracted juice may show
layers of different juices. It is different from separation due to oxidation
caused by juicing with a high-speed juicer..
Loading ...
Loading ...
Loading ...