Loading ...
Loading ...
Loading ...
Instructions for the user
9
4. USING THE HOB
4.1 Lighting the hob burners
Before lighting the hob burners, check that the flame-spreader crowns are
correctly in place with their respective burner caps, making sure that the holes 1
in the flame-spreaders are aligned with the plugs 3 and thermocouples 2.
To prevent damage to the work top, the hob comes complete with a raised pan
stand 4: This must be placed under pans with a diameter greater than those
indicated in the table in point "4.3 Cookware diameters". In any case, pans with
a diameter greater than 28 cm must be used solely on the central burner.
The pan stand 4 can also be used with woks.
The burner controlled by each knob is shown next to the knob. The appliance is
equipped with an electrical ignition device. Simply press the knob and turn it
anti-clockwise to the maximum flame symbol , until the burner lights.
On valved models, once the burner is lit, keep the knob pressed for a few
seconds to give the thermocouple time to heat up. The burner may go out when
the knob is released: in this case, the thermocouple has not heated up
sufficiently.
Wait a few moments and repeat the operation, keeping the knob pressed for
longer. This is not necessary on burners that are not equipped with a
thermocouple.
Once the burner is lit, the flame can be adjusted as required. Always check that
the control knobs are in the O (off) position when you finish using the hob.
If the burners should go out accidentally, after about 20 seconds a safety device
will be tripped, cutting off the gas supply, even if the gas tap is open. Turn off the
control knob and wait at least 1 minute before trying to re-light the burner.
1
2
3
1
2
3
4
Loading ...
Loading ...
Loading ...