Loading ...
Loading ...
Loading ...
5 The display shows the following icon to indicate that the machine enters
the descaling cycle. If you want to exit the descaling cycle, press the ESC
button.
6 Pour the entire bottle of Saeco descaling solution (250ml) into the water
tank.
7 Add water to the descaling solution in the water tank up to the CALC
CLEAN indication.
8 Place a large container (1.5 l) under the steam wand and dispensing
spout.
9 Press the OK button to start the descaling cycle.
-
The machine dispenses the entire descaling solution at regular intervals
through the steam wand and dispensing spout (this takes approximately
25 minutes).
10 Wait until all of the descaling solution has been dispensed. Remove and
empty the container.
11 Remove and empty the drip tray. Slide the drip tray back into the
machine.
12 Rinse the water tank and fill it with fresh water up to the CALC CLEAN
indication. Slide the water tank back into the machine.
13 Place the container back under the steam wand and dispensing spout.
14 Press the OK button to start the rinsing cycle (this takes approximately 4
minutes).
CALC
CLEAN
-
The display shows the following icon to indicate that the rinsing cycle is
finished.
15 The display shows a tick icon. Press the OK button to return to the main
menu.
16 Rinse the water tank and fill it with fresh water up to the MAX level. Put
the water tank back into the machine.
17 Press the OK button to end the descaling cycle.
18 Place a container under the steam wand and dispensing spout.
19 The display shows the following icon to indicate that the machine is
heating up.
-
The machine performs an automatic rinsing cycle.
20 Remove the container. Remove and empty the drip tray. Slide the drip
tray back into the machine.
21 Place the water filter back in the water tank. Reinsert the automatic milk
frother.
22 Remove and rinse the brew group see chapter ‘Cleaning and
maintenance’, section ‘Clean the brew group’.
The machine is now ready for use.
Interruption of the descaling cycle
Once the descaling cycle has started, you must complete it till the very end
without turning off the machine. In case you get stuck during the cycle or in
case of power failure or accidental disconnection of the power cord, you
can exit by pressing the standby button. If this occurs, empty and rinse
carefully the water tank, then fill it up to the CALC CLEAN level. Follow the
instructions in chapter ‘First installation’, section ‘Manual rinsing cycle’
16
English
Loading ...
Loading ...
Loading ...