Loading ...
Loading ...
Loading ...
Operating pressure 700hPa - 1060hPa
Altitude Max. 3000m
Emitted wavelengths 530nm - 1400nm
Optical exposure 2.5 - 5.0J/cm², depending on chosen setting
Maximum optical energy 20J
Pulse duration
<2.5 ms
Repetition time 1-3.5 s, depending on chosen setting
Optical homogeneity
Max. +/- 20% deviation from average optical
exposure in treatment area
Troubleshooting
This chapter summarizes the most common problems you could encounter
with the device. If you are unable to solve the problem with the information
below, visit www.philips.com/support for a list of frequently asked questions
or contact the Consumer Care Center in your country.
Problem Possible cause Solution
The device/adapter
becomes warm during use
This is normal. No action required.
When I place the device on
the skin it does not release
a flash. The ' ready to flash
light blinks orange and
then lights up orange
continuously.
You skin tone in the area to
be treated is too dark.
Treat other body areas with lighter skin
tones with Lumea.
The 'ready to flash light'
doesn't light up when I
place the attachment on
my skin, but the cooling fan
works.
The device is not completely
in contact with your skin.
Place the device at a 90 degree angle on
the skin so that the integrated safety
system is in contact with your skin.
The 'ready to flash light'
lights up white but the
device does not produce a
flash when I press the flash
button.
The device needs to be reset. To reset the device, switch it off and
switch it on again.
The device needs to be reset. To reset the device, switch it off and
switch it on again.
The intensity lights are
blinking alternately, going
from 1 to 5, then 5 to 1.
The overheat protection has
been activated.
When the overheat protection has been
activated, the fan still works. Do not
switch off the device, but let it cool down
for approx. 5 minutes until the lights stop
blinking alternately.
24
English
Loading ...
Loading ...
Loading ...