R1210TY User Manual

Loading ...

Open the bottomof the carton,bend the carton aps back and tilt theoven over

to rest on plastic foam pad. Lift carton off oven and remove all packing materials,

WALL and TOP CABINET TEMPLATE, Turntable, and Turntable Support. SAVE THE

CARTON AS IT MAY MAKE INSTALLATION EASIER.

1. Remove the feature sticker from the outside of the door, if there is one.

2. DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the right side

wall of the oven cavity. Check to see that there is a WALL TEMPLATE and TOP

CABINET TEMPLATE. Read enclosures and SAVE the Operation Manual.

Check the oven for any damage, such as misaligned or bent door, damaged door

seals and sealing surfaces, broken or loose door hinges and latches and dents inside the cavity or on the door.

If there is any damage, do not operate the oven and contact your dealer or SHARP AUTHORIZED SERVICER.

UNPACKING AND INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

Please read all instructions thoroughly before installing the Over the Counter Microwave Oven. Two

people are recommended to install this product.

If a new electrical outlet is required, its installation should be completed by a qualiﬁed electrician

before the Microwave Oven is installed. See 3 ELECTRICAL GROUNDING INSTRUCTIONS on page 7.

1 MOUNTING SPACE

This Microwave Oven requires a mounting

space on a wall as shown in Figure 1. It is

designed to be used under standard 24-inch

wide wall cabinets.

2 WALL CONSTRUCTION

ThisMicrowaveOvenshouldbemountedagainstandsupportedbyaatverticalwall.Thewallmustbeatfor

properinstallation.Ifthewallisnotat,usespacerstollinthegaps.Wallconstructionshouldbeaminimumof

2” x 4” wood studding and 3/8” or more thick dry wall or plaster/lath. The mounting surfaces must be capable of

supporting weight of 110 pounds—the oven and contents—AND the weight of all items which would normally be

stored in the top cabinet above the unit.

The unit should be attached to a minimum of one 2” x 4” wall stud.

Tondthelocationofthestuds,oneofthefollowingmethodsmaybeused:

A. Useastudnder,amagneticdevicewhichlocatesthenailsinthestud.

B. Useahammertotaplightlyacrossthemountingsurfacetondasolidsound.Thiswillindicatestudlocation.

Thecenterofthestudcanbelocatedbyprobingthewallwithasmallnailtondtheedgesofthestudandthen

placing a mark halfway between the edges. The center of any adjacent studs will normally be 16” or 24” to either

side of this mark.

Figure 1

UNPACKING AND EXAMINING YOUR OVEN

24"

Loading ...

User Manual - Page 6