Loading ...
Loading ...
Electrical Connection
WARNING - THIS APPLIANCE MUST BE EARTHED
CAUTION - if you use this heater in conjuction with a thermal control, programme
controller, timer or any device which switches the heater on automatically observe all
safety warnings at all times.
DO NOT pull the heater along by the mains lead.
The use of an extension lead or multi-plug adaptor is not advised when connecting this
product to the mains. Connection through these devices could lead to overloading,
overheating and even re at the extension lead or adaptor due to inadequate connection
quality.
The heater is designed for operation on an AC electricity supply, and is suitable for use
in domestic dwellings and similar indoor locations. This heater must be used on an AC
supply only and the voltage marked on the heater must correspond to the supply voltage.
It is tted with a cord and plug ready for use. The length of exible cable type H05VV- F
size 3 x 1.0mm
2
on all models.
WARNING - The heater complies with stringent safety standards but to ensure ecient
operation surfaces of the heater will become hot and contact with these surfaces should
be avoided, particularly the air outlet grille and the front panel.
Please note that lit cigarettes, candles and oil burners, combined with the convection eect
of electric heaters can cause soot depoists to build up on the surface directly above and to
the sides of the heater. This is not the fault of the heater. Extensive burning of candles or
smoking in the operating environment of this product can produce heavy discolouration
within a few months of use.
Safety - Overheat protection
For your safety this applaince is tted with a thermal cut-out. In the event the product
overheats for some reason, the cut-out prevents excessive temperatures on the product
by cutting the power to the heater. Once cooled down, it will reset automatically, it will
continue to cycle on and o until the reason for overheating is removed.
The display screen will ash red to indicate the product has overheated. To reset the
display, remove the obstruction and hold Enter for 10 seconds.
3
Loading ...
Loading ...
Loading ...