Loading ...
Loading ...
Loading ...
6 49-80393-4
Care and Cleaning
Professional Range Hood
For your
safety
Pour votre
securité
Before servicing or cleaning unit, switch power
off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally. When the
service disconnecting means cannot be
locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
Avant de réparer ou de nettoyer votre appareil,
débranchez le courant au niveau du panneau
de service et verrouillez les mécanismes de
débranchement de service pour éviter tout
branchement accidentel au courant. Si vous
ne pouvez pas verrouiller les mécanismes
de débranchement de service, attachez
soigneusement un avertissement bien visible,
comme une étiquette, au panneau de service.
Mesh grease
filters and
drip tray
(on some
models)
Some models have 2 metal reusable grease
filters and drip tray.
The metal filters and drip tray trap grease
released by foods on the cooktop. The filters
also help prevent flaming foods on the cooktop
from damaging the inside of the hood.
For this reason, the filters must ALWAYS be
in place when the hood is used. The grease
filters and drip tray should be cleaned every 6
months, or as needed.
To clean the drip tray, drain and wipe all
excess grease with a dry paper towel. Wash
with hot soapy water. Dry with a clean cloth.
To clean the grease filters, soak them and
then swish them around in hot water and
detergent. Don’t use ammonia or ammonia
products because they will darken the metal.
Do not use abrasives or oven cleaners. Light
brushing can be used to remove embedded dirt.
Rinse, shake and let them dry before replacing.
To remove:
Grasp the filter lock and pivot it open to
release. Pull the filter down and out. Remove
both filters. Grasp the drip tray, on both sides,
by the front edge and carefully lift it up and out.
To replace:
1. Place and seat the drip tray into the hood
track, making sure the rear tabs on the tray,
hook into the back slots in the hood track.
2. Place the bottom of the filter in the lower
hood rail.
3. Push the top of the filter back, open the filter
lock and snap it into place.
Grease Filters
Filter Locks
Drip Tray
Loading ...
Loading ...
Loading ...