Loading ...
Loading ...
Loading ...
8
BEFORE BREWING YOUR
FIRST POT OF COFFEE
Rinsing your coffee brewer:
We recommend flushing out the system
before brewing your first pot of coffee.
Simply fill the reservoir, power on the unit,
and follow steps 1, 3 and 5 on page 9 under
MAKING COFFEE. Do not add coffee!
PROGRAMMING YOUR
COFFEE BREWER
SETTING THE CLOCK
When the coffee brewer is plugged in, 12:00
will flash in the display for 30 seconds,
indicating the unit is in Clock Set mode. If
12:00 stops flashing, simply press the
MENU button 3 times to the CLOCK option
and the time will return to flashing in Clock
Set mode.
Setting Hours and Minutes
Use the up arrow to set hours and the
down arrow
to set minutes. Hold buttons
down to scroll through the digits quickly, or
press and release to advance one digit at a
time. Be sure the PM indicator is on if
setting a PM time. Five seconds after
finishing setting, the unit will automatically
exit Clock Setting mode.
AUTO ON FUNCTION
1.
To set AUTO ON brew time:
Press and hold the AUTO ON button for
2 seconds. The digital display will flash
the default (12:00) or previously selected
time and the AUTO ON button will flash.
Follow directions under SETTING THE
CLOCK (above) to program your start-
brew time. Five seconds after finishing
setting, the unit will automatically exit
Auto On Setup mode. AUTO ON will
appear on the control panel and the
AUTO ON button will illuminate indicating
AUTO ON is activated.
NOTE: To exit AUTO ON Setup mode, you
can also just press AUTO ON button again.
2. To reactivate Auto On feature:
To start at the same time on another day,
simply press the AUTO ON button. The
time will appear, release button and
AUTO ON will appear on control panel
and AUTO ON button will be illuminated.
3. To deactivate AUTO ON:
Press illuminated AUTO ON button;
AUTO ON will not be displayed on
control panel and AUTO ON button light
will turn off.
Charcoal Water Filter
Your coffee brewer comes with a charcoal
water filter that eliminates chlorine, bad
tastes and odors from tap water.
Inserting the Water Filter
• Remove the filter from polybag and soak it,
fully immersed, in cold tap water for 15
minutes.
• Lift the water filter holder out of the water
reservoir.
• Press down on the filter compartment
and pull toward you to open.
• Place filter into the holder and snap it
closed. Be careful – improper placement
can tear the filter skin.
• Flush filter by running cold tap water
through holes in bottom of compartment
for 10 seconds.
• Allow the filter to drain completely.
•
Slide the water filter holder back into
the channel in the water reservoir, pushing
it down to the base of the unit
.
NOTE: We recommend
changing the water filter
every 60 days or after 60
uses, and more often if
you have hard water.
Replacement filters can
be purchased in stores, or by
calling Cuisinart Consumer
Service, or at
www.cuisinart.com
Loading ...
Loading ...
Loading ...