Loading ...
Loading ...
Loading ...
9
Climate class
Ambient temperature
SN
N
ST
T
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
It may not work properly if being left at
a temperature above or below the
indicated range for a long period.
Stand your appliance in a dry place to
avoid high moisture.
Keep the appliance out of direct
sunlight rain or frost. Stand the
appliance away from heat sources
such as stoves, fires or heaters.
Leveling of appliance
For sufficient leveling and air
circulating in the lower rear section of
the appliance, the bottom feet may
need to be adjusted. You can adjust
them manually by hand or by using a
suitable spanner.
To allow the doors to self-close, tilt
the top backwards by about 10mm.
Installing the door handles
For the convenience of transportation,
the door handles are separately
provided in a plastic bag, you can
install the door handles as follows.
1. Lever screw covers on the left side
of the door, and then put them back to
the plastic bag.
2. Match the handle on the left side of
the door, keeping axes of screw holes
in the handle and the door in a line, as
the picture shows.
3. Fix the handle with the special
screws provided in the plastic bag. And
then install the handle covers.
Reversing the door
The side at which the door opens can
be changed, from the right side (as
supplied) to the left side, if the
installation site requires.
Warning! When reversing the door, the
appliance must not be connected to
the mains. Ensure that the plug is
removed from the mains socket..
Tools you will need
8mm socket wrench
Cross-shaped screwdriver
8mm wrench
Thin-blade screwdriver
Note: Before you start lay the
refrigerator on its back in order to
gain access to the base, you should
rest it on soft foam packaging or
similar material to avoid damaging
the backboard of the refrigerator. To
reverse the door, the following steps
are generally recommended.
1. Stand the refrigerator upright.
Open the upper door to take out all
door racks (to avoid racks damaged)
and then close the door.
10mm
Loading ...
Loading ...
Loading ...