Loading ...
Loading ...
Loading ...
27
USA
Adjusting the amount of rinse aid
1. After turning on the machine,
press Time Delay and P+ keys
simultaneously. Keep them
pressed until the countdown 3, 2, 1
is completed on the display.
2. Press P+ to move to position P on
the display.
3. Set to the appropriate level with the
Time Delay key.
4. Turn off the machine with On/Off
key to save the changes.
No rinse aid dispensed in P:0 wash
position.
1 dose of rinse aid is dispensed in P:1
position.
2 doses of rinse aid are dispensed in
P:2 position.
3 doses of rinse aid are dispensed in
P:3 position.
4 doses of rinse aid are dispensed in
P:4 position.
6.10 END OF PROGRAMME
End of Programme indicator will light
up once the washing programme is
over.
1. Press the On/Off button to turn off
your machine.
2. Close the tap.
3. Unplug the machine from the
socket.
C
For energy saving, the
product is automatically
turned off following
the completion of the
programme or if the
programme is not started.
C
Leave your dishes in
the machine for about
15 minutes to cool down
after they are washed.
Your dishes will dry in a
shorter time if you leave
the door of your machine
ajar during this period. This
process will increase the
drying effectiveness of your
machine.
6.11 WATER CUT-OFF
WARNING
If mains water is cut or water inlet
tap is turned off the machine cannot
take water in and E:02 icon will flash
on the programme indicator. As long
as the problem continues, washing
programme is paused and the water
inlet is checked regularly by the
machine; when the water is restored
E:02 icon will disappear after a while
and the washing programme resumes.
6.12 OVERFLOWING
WARNING
If the machine intakes too much
water or there is leakage at any of
the components then the machine
will detect this and E:01 icon will
flash on the Programme indicator.
As long as the overflowing continues
safety algorithm will be active and try
to discharge the water. If overflowing
stops and safety is assured, E:01
icon will disappear. If E:01 does not
disappear, there is a permanent fault.
In this case the authorised service
should be contacted.
Loading ...
Loading ...
Loading ...