Loading ...
Loading ...
Loading ...
Residentia\10
Dishwasher installation steps Now that your aestheic panel has been fitted to the outer door (1) and your
door spring tension (2) has been adjusted (both steps previously outlined
within this user manual), you can now proceed with the installation of your
dishwasher.
— Connect the inlet hose to the cold water supply .
— Connect the drain hose as per the instructions on page 9 of this user
manual.
— Plug in the power cord to your desired outlet.
— Ax the condensation strip (supplied) under the bench-top of cabinet.
Please ensure the condensation strip is flush with edge of bench-top (3).
— Place the dishwasher into position (4).
— Level the dishwasher. The rear feet can be adjusted from the front of
the dishwasher by turning the Allen screw in the middle of the base of
dishwasher use an Allen key (5A). To adjust the front feet, use a flat screw
driver and turn the front feet until the dishwasher is level (5B). Note, the
maximum height adjustment in each of the feet is 50mm.
Important! Your dishwasher must be level for it's proper operation and
wash performance. Use a spirit level to ensure this is the
case.
— The dishwasher must be secured in place. There are two ways to do this:
A. Normal bench-top: Put the right (left) installation hook into the slot of
the right (left) side plane and secure it to the work surface with two
woodscrews (6).
B. Marble or granite bench-top: Bend the right (left) installation hook into
right-angle and put it into the slot of the right (left) side plane and secure
it to the work surface with two woodscrews (7).
\Installation Instructions\
Loading ...
Loading ...
Loading ...