Loading ...
Loading ...
Loading ...
EEF54W / EFF54S Upright Cooker User Manual Page 16
INSTALLING YOUR NEW COOKER
Safety warnings about installation
• The cooker must be installed and serviced only by an authorized person.
• A certicate of compliance must be supplied by Installer and is to be kept by the customer.
• The packing materials must be removed before you install the cooker.
• You must follow the installation instructions in this booklet.
• The surrounding kitchen cabinets must be able to withstand 85°C. We will not accept responsibility for damage
caused by installation in to kitchen cabinets which cannot withstand 85°C.
• The appliance must not be installed in a corner. It must be installed at least 100mm from the side wall.
• The vents; openings and air spaces must not be blocked.
• The anti-tilt plate must be installed to avoid accidental tipping.
• The stabilizing bolt must be installed to avoid accidental moving.
• You must not pull the cooker by the door handles.
• Electricity isolation switch for electric models 32A plug, is to be installed in an accessible position near the
cooker (but not behind cooker).
• If the supply cord or cable is damaged, it must be replaced by an approved service agent or a similarly
qualied person in order to avoid a hazard.
Unpacking and installation Instructions for Installer
Unpacking
• Please check the product and make sure that there is no damage.
• Read the relevant Installation Sections of this Manual. Ensure all is understood..
• Conrm that product is compatible with available electrical connections.
Ensure proposed installation position does not conict with Installation Sections.
• Check the attachment packing in good condition, complete accessories.
• Use screw driver to remove two xed Anti-tilt plate screws and plate.
Locating the cooker
Study the diagrams below to be sure of the dimensions required to locate the cooker safely. Make sure that the top of
the cooker is at least 10mm higher than the level of the bench tops. The appliance has been designed to t in a 540mm
wide gap in kitchen cabinets. The cooker may also be installed at the end of a line of benches or with a free space on
either side.
NOTE: To ensure cooker stability, both the anti-tilt plate and anti-movement/ stability bolt must be installed on the
cooker.
The installation the splash back
• Upon unpacking cooker, using a philips head screwdriver to
remove splashback from rear of cooker.
• Position splash back into tabs at rear of cooker and push downwards
gently until properly in position.
• Screw in splashback from behind to secure in place.
Loading ...
Loading ...
Loading ...